Research Article
Enhanced Hydrophobicity and Oleophilicity of Modified Activated Carbons Derived from Agro-Wastes Biomass for the Removal of Crude Oil from Aqueous Medium
Ukpong Anwana Abel*
,
Otu Gabriel Ekanem,
Oboh Innocent Oseribho,
Uzono Romokere Isotuk,
Akwayo Iniobong Job,
Inyang Udeme Ibanga
Issue:
Volume 12, Issue 4, August 2024
Pages:
80-96
Received:
2 June 2024
Accepted:
18 September 2024
Published:
29 September 2024
Abstract: Crude oil spillage has tremendous environmental impacts and poses severe pollution problems worldwide due to the continuous activities and operations in the oil and gas sector. This has resulted in the urgent need for clean-up techniques such as the use of natural adsorbents which is considered a relatively low-cost, readily-available, efficient, eco-friendly, and easy-to-deploy mode of addressing oil spillage due to its high oil sorption capacity/efficiency, high oil selectivity, oleophilic, enduring, reusability and biodegradable properties. Empty palm fruit bunch and coconut coir were used as precursors to produce activated carbons for oil spill remediation. The influence of varying parameters was investigated using a batch experimental procedure resulting in the crude oil adsorption capacity increasing with a corresponding increase in contact time, initial oil concentration, temperature, agitation speed, and particle size but decreasing in adsorbent dosage. The combination of surface morphological modification and hydrophobicity enhancement resulted in significantly improved adsorption capacity for crude oil removal (2710.0 mg/g and 4859.5 mg/g for EPFBACLA and CCACL.A respectively), as evidenced by both FTIR and SEM analyses. The experimental isotherm data were analysed using various isotherm models and the best-fitted isotherm model was the Freundlich model with a correlation coefficient (R2 = 0.991 and R2 = 0.999) for EPFBL.A and CCACL.A respectively. The kinetic behaviour of the adsorption process was best described by pseudo-second order with R2 values of 0.970 and 0.999 for EPFBACLA and CCACL.A respectively while Boyd model revealed that the adsorption was controlled by an internal transport mechanism and film diffusion was the rate-limiting step. The crude oil adsorption was chemisorption and endothermic owing to the positive enthalpy values (ΔHo = 183.890 KJ/mol for EPFBACL.A and ΔHo = 69.656 KJ/mol for CCACL.A), the positive value of entropy suggested that the adsorption process was accompanied by an increase in the degree of randomness or disorder at the interface between the adsorbent and the adsorbate. A temperature rise led to a decline in Gibbs energy (ΔGo), suggesting that adsorption became more feasible and spontaneous at higher temperatures and the significant activation energies indicated the existence of a substantial energy barrier that must be overcome to initiate the reaction. The results showed the significant capability of the prepared adsorbents to be used as a low-cost, re-generable and eco-friendly adsorbent in oil spill clean-up and is recommended to exploit its usage on a large scale.
Abstract: Crude oil spillage has tremendous environmental impacts and poses severe pollution problems worldwide due to the continuous activities and operations in the oil and gas sector. This has resulted in the urgent need for clean-up techniques such as the use of natural adsorbents which is considered a relatively low-cost, readily-available, efficient, e...
Show More
Research Article
Niger Delta Oilfields Produced Water Characteristics and Treatment Technologies: Challenges and Solutions
Darlington Bon Nwokoma*,
Kenneth Kekpugile Dagde
Issue:
Volume 12, Issue 4, August 2024
Pages:
97-108
Received:
22 August 2024
Accepted:
18 September 2024
Published:
10 October 2024
DOI:
10.11648/j.ajche.20241204.12
Downloads:
Views:
Abstract: The Nigerian Niger Delta oilfields have high water-to-oil ratio ranging from 50% to 95% water content, due to its secondary and tertiary production phases. Oil and gas producers could shut-in such wells, or develop cost effective approach for Produced Water, PW handling to meet reinjection or environmental permissibility. Thus, the study investigated the compositions and treatment techniques of Niger Delta oil and gas fields PW, and proffered solutions for actualizing minimal hazardous contaminants in PW. Characterization of PW from a Flow Station, an Oil processing and a Gas processing facilities showed biogeochemical homogeneity in the PW compositions with high organic and inorganic constituents, which are above injection and disposal specifications. The results of treated PW from the extant PW treatment (PWT) techniques showed that the total dissolved solids (TDS) concentration (6105.9 mg/l) from the Flow Station PW treatment facility did not meet the required specifications for injection into depleted wells or disposal into the environment (2,000.00 mg/l for inland, and 5,000.00 mg/l for nearshore). The salinity contents in the treated PW from the three PWT configurations were 2411.0 mg/l, 2218.6 mg/l, and 2165.4 mg/l, respectively, which were slightly above Nigerian Upstream Petroleum Regulatory Commission (NUPRC) specification (2000.0 mg/l) for nearshore disposal. The chemical oxygen demand (COD) concentration in the treated PW from the three PWT configurations were 153.0 mg/l, 148.1 mg/l, and 141.2 mg/l, respectively, which were above the NUPRC standard (125.0 mg/l). The oil and grease (O&G) concentration in the treated PW were 84.7 mg/l, 51.5 mg/l, and 58.0 mg/l, respectively, which also were above regulatory stipulation (30.0 mg/l) for nearshore disposal. The modular Bio-Unit + Ultra/Nanofiltration achieved more than 95% removal of both organic and inorganic constituents in the PW. Therefore, this study suggests that reconfiguring the extant PW treatment equipment with this cost-effective innovation would be the solution to PW treatment challenges in the Niger Delta oil and gas operations.
Abstract: The Nigerian Niger Delta oilfields have high water-to-oil ratio ranging from 50% to 95% water content, due to its secondary and tertiary production phases. Oil and gas producers could shut-in such wells, or develop cost effective approach for Produced Water, PW handling to meet reinjection or environmental permissibility. Thus, the study investigat...
Show More
